Interested to Buy Any Domain ? << Click Here >> for more details...
How can we calculate the fault level of the distribution
system knowing the percentage impedance of transformer &
subsequent equipments.
- 14 Answers
- 60508 Views
- I also Faced
- E-Mail Answers
Answer Posted / gopal
fault lavel in MVA= Rated power/% of impedence
or
Fault Lavel= 1.732xFault currentxRated Secondry Voltage
| Is This Answer Correct ? | 69 Yes | 28 No |
Post New Answer View All Answers
Which device is used for the source of emission of electrons in a crt?
I want single line diagram for AMF & DG syncronizing panel
A well system is when , no. of bus bar is less or more. Tell me the concept of it.
What will be the current if the resistance total in a series circuit doubles?
What is primary and backup protection?
What is the typical enclosure type used for Indoor switchgear / Outdoor switchgear Units? - In Onshore / offshore Units?
what shoud be strength and weakness to impress interviewer????????
relation between power station capacity and voltage level?
how to carry out Magnetizing Current Test on Distribution transformer and what purpose we are doing this test. why transformer rating in always in KVA ? what ispositive, negative, zero sequence impedence? How ElCB tripping if Neutral touch with ground Why AC & DC capacitor are use in UPS ? why motor rating in KW? how to syncronize two dg sets
Dear all i am kumaravel. now in chennai. my work is control and relay panel auto cad designing.up to 11kv to 400kv then question is i am improving my knowledge. i want some books name and auther are available for this C&R panel related. plese any one help me
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
What is transient response?
what is circuit recombiner and how it is different from circuit breaker
how do we calculate length of starting time and repeated starting of a direct online starter?
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
