hw to calculate flc of motor ? data are:3-phase,50Hz,30kw
Answer Posted / rajkumar r
U CAN FIND FLC OF THE MOTOR IN THE MOTOR NAME PLATE ITSELF.
MOREOVER,
1HP=0.746KW
1KW=1/0.746HP
30KW=30/0.746 HP=40HP
Practically current taken by 1HP motor=1.342A
so full load current of 30kw(40HP) motor=40*1.342=54A
Is This Answer Correct ? | 20 Yes | 32 No |
Post New Answer View All Answers
What is meant by vector group
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
How many kw will suply from one db
How can calculate the rating of a servo stabilizer for given a specific load
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
physical identification of HT & LT panel
What’s electric traction?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
what can be the causes of capacitor start motor having a higher current that its actual
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
1.what is the funtion of chiller primary & scondary pumps. 2.what is the use of distribution lines & Types. 3.what is the use the thermal power stations & how much capacity.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me