Interested to Buy Any Domain ? << Click Here >> for more details...
How the starter control the starting current in three
phase AC Motor?(In DC apply the reistance).
- 6 Answers
- 16294 Views
- I also Faced
- E-Mail Answers
Answer Posted / l.veeraragavan
Normally starting current of induction motor is 6 to 7
times of the full load current.This because high
inersia(mass) of the rotor.So more current require to
move this rotor.So if we insert he resistance in series
with ckt (in starting only, after starting we gradually cut
this resistance from Ckt) ,we can reduce this starting
current. i.e The function of the starter is inclde
resistance during,after starting it will gradullay cut the
resistance.
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
What is the application of Dyn1 and Dyn11 vector group of transformer?
What is the effect of positive feedback on stability of the system?
what's the simultenous maximum demand (SMD)..what the diffrent MD and SMD?
Is it true online ups having bypass mode if it is true then why we called ups because it is interrupting power when goes in bypass mode
draw the block diagram of fire alarm?
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
explain PV modules in solar energy generation.
Explain difference between stand by earth fault and residual earth fault protection?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
what is the vvvf in the dumbwaiter?? or lift. what is the actual process?/
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
What is accuracy of a measurement?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
Could u pls tell me the NPCIL electrical engineering interview questions for Executive trainee, and also guide me how to face the interview.
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
