why active power is called as real power or working
component.What is the exact function of active, reactive &
apperent power.
- 3 Answers
- 9784 Views
- I also Faced
- E-Mail Answers
Answer Posted / some one
reactive power is that power that flows to and fro in the
load and it does not have any active part in the load and it
will not be absorbed by the load and where as active power
tha load absorbs tha real power ie VI cosphi apparent
power is the vector sum of the two
| Is This Answer Correct ? | 14 Yes | 12 No |
Post New Answer View All Answers
in dc series motor if field wdg is shorted then
Difference between HRG and NGR. Are they both the same thing
what is negative d.c. voltage, why this voltage is used in base transciever station.
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
describe the Tranformer testing procedure
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
What is difference between insulating medium and fault current interruption medium in a switching device.
Is it good to short Neutral and Ground in the PLC or DCS main Power supply. Pls give YES or NO with reasons...? Simarpreet
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
In a flange coupling, the flange bolts are designed for
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
What is load boxes ?
