what happan when ac power transmitted in unity power factor
- 12 Answers
- 17881 Views
- JE, Maihar Cement, I also Faced
- E-Mail Answers
Answer Posted / rakesh ampuri
when ac power supply is done with unity pf then line loss
can be eleminated volage profile of recieving end become
flate there would not be need compensesion . proper
utilization ele. power can be improved ele. m/c performence
would b increase efficiency would also increase.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
at which voltage level arcing ground is occurs ??????????
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformerÂ
I want to know all basics of electrical engineering
what is dc mator?types of dc motor?losses in dc motor?what is the mechanical,electrical and commercial efficiency of a dc motor?
How Can You Relate Power Engineering With Electrical Engineering?
1.What will be stored in online ups EPROM IC?
Define Electrical Insulation and examples of Solid,Liquid and Gaseous insulating materials?
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
how to calculate the distance relay faulty zone?pls explain?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Define active filter?
