Interested to Buy Any Domain ? << Click Here >> for more details...
why heat produced at junction of two different conductor.
what care should be taken to minimize it.
- 11 Answers
- 18153 Views
- Birla, Maihar Cement, I also Faced
- E-Mail Answers
Answer Posted / kapil gehlot
when two conductor are joined then a contact resistance is
genrated due to that heat is generated and second reason
would be change of electron density and chnage of
resistivity.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
what is the formula of starting current of 3phase and 1 phase motor???
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
WHaT IS THE CONCEPT OF INDUCTION LAMPS IN MODERN LIGHTINGS, and HOW IT WORKS TO EMIT LIGHT ( AS NO ELECTRODES ARE PRESENT ) ?" COULD INDUCTION LAMPS CAUSE INTERFERENCE WITH COMUNICATIONS INTO A STORE USING INDUCTION LIGHTING ? WHAT IS THE BENEFIT OF USING THE LOW FREQENCY INDUCTION LAMP , VERSUS LED , AND VERSUS FLUORESCENT, AND VERSUS ANOTHER KIND OF LIGHTING . THANK yOU MOISES GUINDI
Is it possible to implement Restricted Earth Fault protection for a transformer without neutral CT?
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
Is there any specialised book to refer about fault level calculation both in MV and LV side??
what is the use of the circle diagram
What is the universal motor?
How to check the cable fault / hv test of transformer cable.
What types of question are done for diploma students in aptitude test
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
How to calculate loses in transformer of 160 KVA ?
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
