my field of interest is T&D. plz tell something about that.
Answer Posted / h.s. raveesh(9740655446)
Transmitting higher voltage using stepup transformer to
avoid loss and steping down using stepdown transformer for
distribution purpose.Transmission mission means
Transmitting higher voltages like 11kv,33kv,66kv & 110kvand
Distribution means distribution lower voltages like 230v or
440v
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the Connected Load (kW) or Contract Demand (kVA)of mahindra nasik plant??
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
What do you mean by dependent and independent voltage sources?
HOW CAN I GET 5CORE HO7 CABLE SIZE IF I HAVE 1800A?
Name a govt approved university which have 100% online engineering course.
bus bar design conditions and sizing pls tell me quickly
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
how to calculate current and voltage in a same circuit?
v/f drive basic princeple
what is the meaning of the symbol << >> put in transformer drawing
what is the setting of locked rotor in HT motor ? (answer expecting in percentage)
what is ps impedance test
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?