Interested to Buy Any Domain ? << Click Here >> for more details...
Is voltage & potential transformer are the same? Are they
used for same application ?
- 11 Answers
- 18722 Views
- I also Faced
- E-Mail Answers
Answer Posted / priydharsini.r
Yes VT and PT are same.
it is mainly used for Protection and metering.
the Tx.line have high voltage. if you want to measure the
voltage it should also designed with HV. it leads more cost.
therfore we are steping down the voltage to a low level. it
is usally 110V.
also it is used for distance protection. the distance
protection is based on Impedance. Impedance can be
calculated by using the formula Z= Voltage/Current.
| Is This Answer Correct ? | 19 Yes | 3 No |
Post New Answer View All Answers
what is the purpose of high speed earth switch in gas insulated substat
How are load losses and no-load losses measured at site in a DG set?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What is the difference between Encoder and Resolver?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
what is working process of star delta controlling circuit ?
why constant voltage transformer should be start without load? and if started then what will happen?
How we can defined theecopper cable size if we know the aluminium cable size?
what percent do you derate your copper wire when you change from copper buss to copper wire
What is mean by Sensitive Earth fault & what are the effects
How the setting of the vector surge relay shall be calculated when the relay is to be used for Grid islanding application?
What is excitation in case of dc motor?
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
