Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dolphin
nirbhay's answer is absolutely correct. the jet
trains in japan which can accelerate their speed
upto 500km per hour
are the best examples of linear motor. here the
train acts as a linear rotor which is excited with
3 phase supply and the rails act as a unrolled
stator which contains short circuited cross bars.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
What is dielectric loss?
Write a note on materials used as a fuse element.
What is meant by coupling capacitor?
why and how current drawn by battery charger depends upon the altitude where it is located?
What is the lower limit of break-down voltage of converter transformer.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
whether fibre optic cable in high voltage earth conductor is used for protection circuits
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
Why we are use dol starter up to 10 hp
