why earth hole size is biggest in plug point?
Answer Posted / ritesh gupta
earthing is used for human & equipment protection purpose.
resistance of big cross sectional area conductor is less so
current will be flow in low resistance path.
Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
WHY RATING OF VCB NOT LESS THAN 630A
Is MEN and RCD related to each other ?? IF yes then how??
why ht motors are star connected?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
How to calculate multiplying factor of dc energy meter
Why saturation region slowly shifted in the left side?
What is the basic rule for block diagram reduction technique?
PLZ EXPLAIN THE INTERLOCKING AND CONTROLLING OF CONTACTORS????HOW CAN I DO THAT?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
What is difference between safe PLC and normal PLC
what is the difference between droop mode and ischnorous mode in thermal powerplant?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
HOW MANY TYPES OF FUSE?
Why is a plain induction motor unsuitable for wide speed control?