what is the difference between electrical & electronics




Answer Posted / ritesh gupta

electrical deals with high voltage & high current.
but electronics deals with low voltage & low current.
electronics used for controlling purpose of electrical quantity

Is This Answer Correct ?    164 Yes 68 No






Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

what topics we have to concentrate for power grid et.written test.and tell what to read for english synonyms and antonyms.

765


- two pumps must work with them at the same time but if the first pump start the second pump  must delayed for some time to start  also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it

1485


electrical

1024


wish of these transformer uses oil?

475


During Starter Panel Com missing I Found The Main Incomer 40Amp MCB 10KA Trip When Motor Change Star To Delta Motor Rating 20HP BUT When We Use Same MCB To Other Motor It Does Not trip Or What Is Necessaries for Star Delta Starter MCB SFU MPCB OR MCCB And What are The Breaking Capacity of MCCB in the Motor above 15HP

759






what is the setting of locked rotor in HT motor ? (answer expecting in percentage)

1073


can we use trip light with bus coupler?

717


in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter

946


in science exhibition how lamp can blink when you clap near the lamp ? thank you

720


Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?

653


According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor

833


what is the saturation point of crgo lamination.

846


How to know vacuum in vacuum cylinder of breaker in working condition

634


how we can calculate chiller required ampear?

850


in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?

728