What is the advantega and disadvantage of SCPC(Single
Channel Per Carrier) ?
- 3 Answers
- 8770 Views
- Airtel, Vodafone, I also Faced
- E-Mail Answers
Answer Posted / gerald francis suresh
noise and distortions are very low because single channel
means, i hope that is single video broadcasting, any kind of
video has only the frequency of 0-5Mhz, multichannel will
affect the reliability of the communication. or the
communication should be multiplexed with frequency, time or
phase.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Which register which contains the instruction that is to be executed?
why germanium is most suitable for DWDM systems?
What is channel coding?
What is the tri state of a signal?
what is perfect balance in opamp?
Explain find conductivity, resistivity and resistance?
What is Banked Register in Arm 7?
Define circuit switching?
What are the main components used for isolating the power circuits, power semiconductor from the low-power circuit?
Why slew rate is not infinite in ideal op-amp?
What is a dc power supply?
How many maximum PWSA cards can be inserted in a Ultra BTS cabinet How many maximum PWSB cards can be inserted in a Ultra BTS cabinet How many maximum PWSC cards can be inserted in a Ultra BTS cabinet What is the output power rating of one PWSA card What is the output power rating of one PWSB card What is the output power rating of one PWSC card What is the function of Receiver Multicoupler (M2xA or M6xA) How many TRX's are supported by one Receiver Multicoupler- M2xA How many TRX's are supported by one Receiver Multicoupler- M6xA What is the function of Remote Tune Combiner (RTxx) unit The FIU19(E) units main LED is red. What is the meaning?
If R1=R2, then B=0.5, the total time T of square wave in astable multivibrator using op-amp is A T=RC B T=2 RC ln 3 C T=2 RC ln 2 D T=2RC ln (1+ 0.5)
Why are using 4ma to 20ma for signal transfer. Why not 0 to 20ma?
write the expression for a multiple Pi section filter's ripple factor?
