Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / guest
Cause: The protocol adapter requested (by way of the
"(PROTOCOL=..)" keyword-value pair in a TNS address) is
unknown. If the supplied address is typographically correct
then the protocol adapter is not installed.
Action: Install the protocol adapter or correct
typographically error, as appropriate. Note: if the supplied
address was derived from resolving the service name, check
the address in the appropriate file (TNSNAMES.ORA,
LISTENER.ORA or SQLNET.ORA).
Please add more information about this Error
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
if the lengths of two wires are same and the area of cross sections is 4:7 then what will be the ratio of current passing through these wires
NZE-28890: Entrust Login Failed
ORA-26095: unprocessed stream data exists
ORA-16627: No standby databases support the overall protection mode.
ORA-26076: cannot set or reset value after direct path structure is allocated
ORA-26079: file "string" is not part of table string.string
IMP-00063: Warning: Skipping table "string"."string" because object type "string"."string" cannot be created or has different identifier
invalid quantity specification negative quantity are not allowed for this item please check this item definition quantity
when i ran any workflow or session, getting below error: seesion task instance[s_xxx]: Execution terminated unexpecterdly
IMP-00096: Warning: Skipping table "string"."string" because type synonym "string"."string" cannot be created
Hi guys, I have four tables those are emp,dept,eliminate and uneliminate. i wrote small cursor..when i run, it display one error (ORA-01403 nodata found)... The query is: Declare cursor c1 is select e.ename emp_name from emp e,dept d where e.deptno=d.deptno group by deptno; r1 c1%rowtype; test_emp varchar2(200); begin for r1 in c1 loop begin select eliminate_emp into test_emp from eliminate t,uneliminate ut where t.number=ut.number and t.deptno=e.deptno and rownum<1; end; dbms_output.put_line(r1.emp_name); end loop; end; Thanks...
How to resolve QSM-01108 error. I have no OR conditions in my query, but do have 9 IN conditions. The error says the max limit is 2 while I have 257 number of disjuncts. However, if I remove even a single IN condition, the query is rewritten. I cannot change my query. How can I resolve this issue?
ORA-26084: direct path context already finished
ORA-16626: failed to enable specified object
ORA-26082: load of overlapping segments on table string.string is not allowed
