Distinguish between the shear center and elastic center.
- 1 Answers
- 1412 Views
- I also Faced
- E-Mail Answers
Answer Posted / Rajesh Tejan
"The shear center (S) is a point in a rigid body where torsional moments act without producing any rotation about that point. The elastic center (E) is a point in a deformable body where the couple produced by two forces would not cause any rotation of the body if the forces were applied at this point. In other words, the shear center is relevant for rigid bodies, while the elastic center is relevant for deformable bodies."n
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
RRB exam model questions pls forward.
Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very thanksful.....srinivas_1704@yahoo.co.in
hi friends kumar here if anybody of u have essar placement papers than plz send it to me i need it urgently..ok mail id is kskalyani@gmail.com
Dear friends, i am a student of mechanical final year in rajasthan. If you have any type (Technical,interview, aptitude) of question paper related to BIRLA CEMENT LTD. than plz send me these paper at vinodsainikumar4@gmail.com thanks
DEAR SIR, I NEED A MODEL QUESTION PAPER OF JSPL. i'M IN mechanical BRANCH. E-MAIL ID:sksuman289@gmail.com
can any body sand me previous exampapers of jr. engineer (mechanical)
How much stack emmission through your chimney and what is the state govt norms ?
plz send me the aptitude test paper for hpcl.
sir please send previous question papers of technician grade III of all rrb's. thank you
hello, this is sai preparing for mvi exam if any having previous year question papers please help me out
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.
RRB exam qustions.
hi, if anyone have previous year paper of NHPC or some questions, Please send me at gupta.pankaj20@gmail.com
Hoew to represent unilateral tolerance, as Bilateral tolerance in engg drawing...? Example: 1.295 +0.000 and -0.10, as unitolerance, write the value in bilateral tolerance?
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
