Answer Posted / Pintu Kumar Paswan
Milliamperes (mA) are a unit of electrical current, whereas flow typically refers to fluid flow in a pipeline. There is no direct conversion between milliamperes and flow. However, in some instruments, the flow rate may be indirectly related to the electric current through sensors or transducers.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
What is the Working principle of Dozing valve?
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
where cascade loop use ?
send me last 5 years questions asked in rrb chennai, for section engineer
can any send me a forbes marshall dtron 316 manual
principle of dead weight tester ?
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
any body please send me the old question papers of ongc test.
