Answer Posted / Rakhi Kumari
A Zone in Fire Alarm Systems refers to an area or section of a building that shares the same fire detection and alarm characteristics. Each zone has its own set of smoke detectors, heat detectors, pull stations, and other fire-related equipment.nnA Loop/Fire Alarm System is a network configuration where devices such as sensors, control panels, and annunciators are interconnected to create a continuous circuit. This allows for the transmission of alarm signals throughout the system. In case of a break or fault in one part of the loop, the system can still operate through alternative paths.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
use of split range ? where it is used ? in which control loop it is used ?
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
Questions on flow meters,few questions on HART protocol,
give me all the details about the interview and which type of question being asked
plz send me general of ongc
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Question on maha cement
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
principle of dead weight tester ?
send me last 5 years questions asked in rrb chennai, for section engineer
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
where cascade loop use ?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
