Answer Posted / Krishan Kant Sharma
In MTS LT (Measurement, Test, and Simulation Laboratory Tool), Loop1 and Loop2 are two control loops that allow users to perform complex test sequences with multiple iterations. Loop1 controls the main sequence of tests, while Loop2 can be used for nested or repeated tests within the main loop.nThe behavior of each loop is determined by a set of instructions called a script, which defines the actions to be performed, the conditions for looping, and the logic for making decisions.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
send me model hpcl questions pleas..........my mail id mohideen.dharvesh@gmail.com
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
sir, give me placement papers and interview quistion of birla group company of copper.
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
plz send me general of ongc
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
can any send me a forbes marshall dtron 316 manual
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
use of split range ? where it is used ? in which control loop it is used ?
