Type of level transmitter commnly used in Procees area are the
following.
a.________________This type of level transmitter works as
follows
- 1 Answers
- 2166 Views
- I also Faced
- E-Mail Answers
Answer Posted / Anil Bharati
1. Capacitive Level Transmitter: This type of level transmitter works by measuring the changes in the dielectric constant of a material, which varies with the level of the liquid being measured. The capacitance between two electrodes within the transmitter changes based on the level of the liquid, and this change is used to determine the liquid level.
a. Capacitive Level Transmitter: This type of level transmitter works as follows:
- The transmitter consists of a pair of electrodes that are separated by a dielectric medium (usually air or a gas).
- When a liquid fills the space between the electrodes, it changes the dielectric constant, causing a change in capacitance.
- This change in capacitance is measured and used to determine the level of the liquid.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
give me all the details about the interview and which type of question being asked
use of split range ? where it is used ? in which control loop it is used ?
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
Punj lloyd is coming in our Jadavpur Universtiy campus for campus placement. Please send me some hints about the writtend exam. My email id is subratafriends@gmail.com
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
plz send me general of ongc
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
any body please send me the old question papers of ongc test.
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
principle of dead weight tester ?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
please send data bank of quetions answers on analytical instrumentation.
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
