i have one air blow heater , coiled heater is in side hollow
ceramic tube and passing the air and other end hot air is
going out,
to control the hot air where i should fix up a THERMOCOUPLE
on the heater or on the out let of hot air terminal which
is the best way
- 1 Answers
- 2127 Views
- I also Faced
- E-Mail Answers
Answer Posted / Sanjeev Kumar Verma
To accurately measure the temperature of the heated air exiting your air blow heater, it's recommended to place the thermocouple near the exit point, as close as possible without coming in direct contact with the heater elements. This setup will provide an accurate measurement of the heater's output temperature.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is alternater & engine genral protection?
can you give me the solution of iiie
what are the different ripple removing circuit . which one is better and why
plz send me l&t auestion papers. i have been called for written and interview industrial automation 2 yrs exper. send me on mail pal_deepak06@yahoo.com
Anyone answer what is average cost for 1 meter GI pipe Hot dipping
