Answer Posted / guest

Cause: A failure occurred during initialization of a network
connection from a client process to the Oracle server: The
connection was completed but a disconnect occurred while
trying to perform protocol-specific initialization, usually
due to use of different network protocols by opposite sides
of the connection. This usually is caused by incorrect Net8
administrative setup for database links or external
procedure calls. The most frequent specific causes are: --
The connection uses a connect string which refers to a
Heterogeneous Services agent instead of an Oracle server. --
The connection uses a connect string which includes an (HS=)
specification.

Action: Check Net8 administration in the following ways: --
When using TNSNAMES.ORA or an Oracle Names server, make sure
that the client connection to the ORACLE server uses the
correct service name or SID. -- Check LISTENER.ORA on the
connection end point's host machine to assure that this
service name or SID refers to the correct server. -- Confirm
in TNSNAMES.ORA or the equivalent service definition that
the connect string does NOT contain (HS=).

Please add more information about this Error

ORA-07497: sdpri: cannot create trace file 'string'; errno = string.

2313

---

When i am connect database through toad,one error occured. ORA-12514: TNS:listener does not currently know of service requested in connect descriptor. plz help me thanks advance.............

2317

---

ORA-26076: cannot set or reset value after direct path structure is allocated

1472

---

ORA-26095: unprocessed stream data exists

2803

---

ORA-26030: index string.string had string partitions made unusable due to:

1559

---

---

ORA-16516: The current state is invalid for the attempted operation.

8064

---

ORA-16626: failed to enable specified object

1771

---

Hi guys, I have four tables those are emp,dept,eliminate and uneliminate. i wrote small cursor..when i run, it display one error (ORA-01403 nodata found)... The query is: Declare cursor c1 is select e.ename emp_name from emp e,dept d where e.deptno=d.deptno group by deptno; r1 c1%rowtype; test_emp varchar2(200); begin for r1 in c1 loop begin select eliminate_emp into test_emp from eliminate t,uneliminate ut where t.number=ut.number and t.deptno=e.deptno and rownum<1; end; dbms_output.put_line(r1.emp_name); end loop; end; Thanks...

2139

---

if the lengths of two wires are same and the area of cross sections is 4:7 then what will be the ratio of current passing through these wires

2232

---

ORA-26082: load of overlapping segments on table string.string is not allowed

1376

---

invalid quantity specification negative quantity are not allowed for this item please check this item definition quantity

2857

---

RMAN-05017: no copy of datafile number found to recover

1881

---

ORA-26028: index string.string initially in unusable state

3398

---

IMP-00096: Warning: Skipping table "string"."string" because type synonym "string"."string" cannot be created

1237

---

NZE-28868: Peer certificate chain check failed.

2263

---