Interested to Buy Any Domain ? << Click Here >> for more details...
no of comparators required for 4 bit parallel A/D comparator
- 4 Answers
- 9114 Views
- I also Faced
- E-Mail Answers
Answer Posted / pradeep
2 power of 4 - 1 ie
16 - 1 = 15.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
explain the trasistor sizing procedure for a four inputNOR and four input NAND Gate?
sir i need a few nots of electronics component cicuit plz send me some nots
what are control system components?
Is reverse saturation current of a diode is independent of reverse bias voltage?
What is meant by step-up cyclo-converters?
why we using different type of microwave antenna we using like one is connected to MMU and one more is connected to other slot what is use of both antenna?
How can level transmitter in closed tank application be used
The loss of precision in quantity is called A Down time B Delay C Unavoidable delay D None of these
In micro controller individual pin output current is 1.6ma .Normally to blink a led we need minium 10-12 ma. But if we connect led to the micro controller pins without additional device it blinks. How it is possible
What are the function of different capacitor, resistors, transister, diods, thyrister( like SCR)in any circuit?
Explain the approximate cost of the monitoring cables time domain reflectometry?
simplification of Boolean Expression- A+A'B.
What will happen if we change the polarity of microwave antenna?
What are active & passive elements in BTS?
What is the difference between silicon controlled switch (scs) and gate turn-off switch (gto)?
