Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / saquib hassan
This test is done to determine the initial and final setting times of cement.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
specifications of fe500 steel
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
How to fix the reinforcement in footing shorter bar at bottom and longer fix at top.
How reactor of SBR installed , is it be over ground, fully under ground or semi sunk ?
Where is the worlds longest elevator and how long is it?
For 1 bag cement how i will calculate sand and metal aggregate;Here the mix proportion is 1:2.49:2.38
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
Formula for calculation volume of essentric footing
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
how to preaper for interview wat they asked in interview give me idea
if 20mm aggregate is coming by weight 25 ton in a 10 wheeler hywa ,then what will be total volume of aggregate in cubic feet.
for G+2 residential building how much quantity of required in foundations,sub & superstructures per sq ft area
What are the materials used in building a gravity dam?
hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft
WHAT THREE SPECFIC JOB POSITIONS TO YOU TARGET FROM THE COMPANY?
