Interested to Buy Any Domain ? << Click Here >> for more details...
I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?
- 3 Answers
- 4411 Views
- OPaL, I also Faced
- E-Mail Answers
Answer Posted / ajay
First the question is not correct. for air to open if given 100% air, then valve should be fully open, not close ...clear your question
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
What is the purpose of LO Overhead tank in turbines.
What is stripper & spilitter ? Diffrence in this.?
what is function of switch, and how is it work, explain with difination
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
Any one can help me to identified, how can we interchange the device in FF
Explain the difference between mmwc and mmwg?
what is a half wave, full wave, and bridge rectifer.
Differentiate between ultrasonic flowmeter and radar type flow meter
Name different parts of a pressure gauge.
how to commission furnace ( water heater)
Questions on flow meters,few questions on HART protocol,
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
what is function of SCADA , and how is it work, explain with difination
Why we are using DPT(Differential Pressure Transmitter) in separator instead of level trasmitter?
