Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ahmed
For understanding difference between plc and dcs watch this video.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain the working of an enraf level gauge.
How to calibrate the flow transmitter
ORP sensor working principle?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
what deference between panel earth and systemearth
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
i need some objective type questions in instrumentation
what is the input of digital counter during the the calibration time?
What is modbus?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
if my flow is 20000 m3/h than which range of DPT i have to use????
why is an oxygen sensor used in a boiler stack
