How will you select suitable Instrument for Process
line/Tank/Vessel?
- 5 Answers
- 8165 Views
- I also Faced
- E-Mail Answers
Answer Posted / tamilselvan
Depending upon process variables and process material type (liquid or gas).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
any body please send me the old question papers of ongc test.
sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
Question on maha cement
principle of dead weight tester ?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
can any send me a forbes marshall dtron 316 manual
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
where cascade loop use ?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
sir, give me placement papers and interview quistion of birla group company of copper.
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
