Answer Posted / iftekhar ahmad
An Anubar has more then one hole into pressure measuring chember.
The pressure in the high pressure chember represents the average of the velocity across pipe line.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why thermo wells are used? What materials are used in thermo wells?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what is orfics working in main steam line. is it increase pressure, velocity of steam flow and dicrease steam flow rate. or any other
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
what is cold loop? difference between hot and cold loop?
Identification of ss fittings, pilot valves, relief valve.
What is loop1 and loop2 in MTS LT?
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
Differentiate between ultrasonic flowmeter and radar type flow meter
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
what is function of SCADA , and how is it work, explain with difination
State some of balance principle’ advantages?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
How to calibrate level transmitter with use of HART?