What are the different protection systems takes place on
control panel board?
Answer Posted / powerplantguruji
Interlocks:
Are the programmed or hardwired control systems to protect systems and improve the operation reliability.
Protections:
Are the programmed or hardwired control systems to protect the equipments, man power and systems from failure/harm.
To read more click here...
https://www.powerplantguruji.in/2020/11/interlock-permissive-protection-thermal-power-plant.html
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
Why are cables rated for 40 KA for 0.25 Sec fault current rating?
what is the significance of tan&delta and how it performed in power transformer
what is gridrotor resistance starter
a battery is having capacity 100AH and 25% charging .if a load taking 10A & connected 6 hour .what is the final condition of the battery.
33kv substation lay out details & line to line & line to earth measurements
send me any model test paper of clerical post of state bank of india.......
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"
What is real time power factor control panel(RTPFC)?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
what material is used in capaciter
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"