The coefficient of friction for the Asbestos-based materials used for clutch facing is
a) 0.07
b) 0.17
c) 0.27
d) 0.37
Answer Posted / biraj saha
0.37
Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Explain the Otto cycle.
Mean effective radius of contact surfaces of a clutch plate is decided by a) Coefficient of friction b) Axial pressure c) Space available in the vehicle d) Amount of torque to be transmitted
Define elastic limit and yield point.
Differentiate between two stroke engines four stroke engines.
What are the different alloys of brass?
What are sliding contact bearings?
What will happen if wrong fuel is burnt in engine?
The function of Differential is a) To prevent wheel skidding b) To reduce the speed of the inner wheels during turning c) To keep the speed of all the wheels same when going straight ahead d) all of the above
What is a pressure cap in the radiator?
Hi guys! I buyed this clone carprog but i realized that not reading 24cxx. I tried 93cxx and 25cxx and it read.But 24cxx not.I tried to put external power.Of course the eeprom was soldered out.The interface is new and never read 24cxx.I tried many 24cxx .Is there a solution for this problem? I read in other forum that need to replaced 74hc125D with 74hc125M 4 pieces. thanks!
Explain the reason that why big tyres are used in rear of vehicles
The point of interaction of the tractive effort curve and the total resistance curve is called a) Stabilizing speed point b) Low speed point c) High speed point d) Normal speed point
Slip joints are provided in the propeller shaft a) To adjust the inclination of the propeller shaft b) To adjust the length of the propeller shaft c) To prevent the whirling of the propeller shaft d) To adjust the up and down movement of the rear axle
difference bitween CPC & SQC
What is the allowable -ve carnkacse pressure (vacuum) in the gas engine of 1.5 MW, what are the reasons and how it can effect the operation of the engine?