Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / powerplant.calculations
As the temperature increases, the hydraulic test pressure decreases
Normally 20 to 50 degree C water is used for boiler hydraulic tests
Refer below link for such questions & answers
https://www.powerplantandcalculations.com/2020/06/why-how-these-in-boilers.html
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is difference between secondary Air & Tertiary Air and Their use.?
what's the moog valve
what is restricted earth fault explain in details
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
How We Calibrate the vaccum transmitter?
why airtel use + 24 volts and other operators use -48 volt
why do you consider yourself a suitable candidate for this position
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
im try to calculating seawater flow required for SW-FGD system. I need a guide, equation or method to do it, can some one help me! Thanks very much
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
what is the basic use of power plant in equipment
what is the difference between compensated & normal drum level in boiler drum?
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
