Answer Posted / neeraj agrawal
RGGVY-RAJIV GANDHI GRAMIN VIDHUTIKARAN YOJANA
RE-RURAL ELECTRIFICATION
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the most essential condition for the voltage build up for a d.c. Shunt generator?
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
Why syn. Generators are used for the production of electricity?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
how to discharge 3 phase power factor correction capacitors
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?
What is error of a measurement?
What is the Resposiblity of Electrical Utility Engineer
What are the disadvantages of autotransformer?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
What is an alternator impedance value?
What is Electrical Grade Aluminum for Tubular BusBars. i am confused between 6063 and T6 or T5 and what is BS 2898 and BS 159?
is that a problem if i connect a single phase load to a secondry delta connected transformer but i get a neutral from other transformer i the system?
What is the difference between grid and off- grid system??