Interested to Buy Any Domain ? << Click Here >> for more details...
why the voltage transmission is always in a multiple of 11?
e.g. 110 V, 220 V, 33 kVA, 11 kVA
- 16 Answers
- 45958 Views
- IAF, MahaGenco, I also Faced
- E-Mail Answers
Answer Posted / psingla
It's bcoz of form factor which is.
rms value/AVG.value both values are considered bcoz we can get both half & full cycle of AC current
RMS value=0.707 of max. Value of current transmitted
AVG.value=0.637 of max value of AC current transmitted
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
write a program that prints prime numbers from 1-20 in digonal form
WHAT IS MOBILE SUB-STATION? & REALLY BENEFIT IN INDIA
why cable i burning without tripping. how can protect led street lights
i want use the cable size 16cx4 core aluminium usege watts 240x2000w this cable size is correct?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
CBCT selection
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
in dc shunt motor if field winding is shorted then
hi all i like to know vat is power plot in control systems also i want to know abt latest trends in electrical & electronics
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.
why the protection turbo generators is most complex?
how to calculation increase capacitor,increase power factor for three phase.
