In T beam design, which are the regions selected as rectangular and Flanged ?
- 1 Answers
- 1498 Views
- I also Faced
- E-Mail Answers
Answer Posted / mustafa mohammed layeak
1. Midspan of beam is considered as T section for calculating tensile reinforcement at bottom. Here compressive force carried by concrete at top of the section includes effective flanges. 2. For calculating tensile reinf't at top (at supports) for hogging moment the section is considered rectangular. Here compressive force carried by concrete at bottom of the section is simply rectangular. In simple words, Midspan section is considered flanged and End/near supports section is considered rectangular.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to find the cuplock pipe qty in staging for Minor bridge?
How to do rate analysis for concrete work including shuttering work?
Is it worthwhile to carry out tests on particle density of soil particles for geotechnical design?
what is w/c ratio in dry lean concrete for m10 mix design
What is Joule Brayton Cycle?
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?
how do we calculate quantity of cement sand and aggregates in 1m3 of m20 m25 grade concrete?
Which code specifies the specification ofthe construction joints to be provided in the raft slab of a basement which is 6 m deep.what should bethe detail of such a joint?
density of crush sand & crush stone or grit powder
Why do you want to work here
Calculate the maximum allowable speed on a horizontal curve of radius 350m if the maximum allowable values of the lateral coefficient of friction are 0.14 and the rate of superelevation is 0.08.
How to construct a water sump in a rocky soil?
wat would be the probable interview questions and GD topics for IOCL exam?
Explain the water bound macadam roag
