Interested to Buy Any Domain ? << Click Here >> for more details...
What happen if a 18 watt fluorescent tube is used on 36watt choke,which one damaged or not damaged, if damaged why that damaged?
- 2 Answers
- 3153 Views
- Bharat ITI, I also Faced
- E-Mail Answers
Answer Posted / mohandas
The 18 Watt tube light filaments will not be able to with stand the power discharged by the 36 Watt choke and hence the filaments burn out. Nothing will happen to the choke as the circuit is broken when the filaments are burned out.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why 11kv to be generated in generation station
transformer phasor diagram under load explain it?
In EB metering we face problem kva jump even in no load condition.can any one help to control this
draw vector diagram and +ve,zero sequence diagram of symmetrical three phase fault.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
features of hbc fuses
What do you mean by ratio correction factor of instrument transformer?
How do we calculate transformer oil in liter from the rating of the transformer.
please send me the L&T Emb. sys. placement papers and entire details of pattren
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
Write the force balance equation of ideal dashpot element.
What is the Nyquist criterion regarding control systems?
State kirchoff current law?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
How many gap between finger contact in a.c.b. and v.cb.?
