what happens when the supply frequency to the tube light is
reduced to 25Hz....?
- 5 Answers
- 6539 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohandas
The choke is designed to generate a particular amount of high voltage when the starter contact breaks the supply to the choke. This high voltage discharges through the filament and in turn ionises the gas in the fluorescent tube. However when you reduce the frequency to 25Hz the high voltage produced by the choke will reduce considerably which may be insufficient to ionise the gas and the tube may not glow.
However if the frequency is reduced when the tube is already on and working the tube will continue to glow but with less luminosity.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
Why is remote backup preferred to local backup?
Why we use duplex coil and hook switch in telephone system?
application s to shunt coil
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
induction 3 phase motor terminal connection
WHAT IS THE MEANING OG (li = 7 In)
What's the difference between non break power supply and non break non short break power supply
wat is the first thing dat is needed, 2 lay a cable in some area??
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
Readings of ER300P Trivector meter
I am a possesor of c licence from 1993. I forgot to renew during the year 1998. During that time I was working at TNEB to till date. Is there any possibility to get renewed? or to apply for a new one?
can the measured percentage error during calibration of single phase energy meter be negative?
What is the mechanism of WTI
