Interested to Buy Any Domain ? << Click Here >> for more details...
What's voltage?
- 1 Answers
- 2540 Views
- Pakistan Atomic Energy Commission PAEC, I also Faced
- E-Mail Answers
Answer Posted / muhammad riaz
The potential difference between to point.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How shall i select the value of capacitor or inductor in a system?
what is the difference between fault current ant short circuit current?
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)
what is the calculation formula for motor starting torque,running torque, running torque.
What is the reason behind current flow(20 A) in amain earth cable of an SMDB? Is cuurent flow(45A etc) through a neutral cable acceptable?
what is the use of commutator in dc motor if we supply ac ? commutator is used to convert ac to dc.and it is used to arrange the flux in unidirectional in case of dc supply. if we give ac as supply to dc motor what is the use of commutator?
What is the count of hvdc transmission lines in india?
what are types of encoder
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
How does HT work & Voltage required?
grr resistance & contrator malt continuous
