Interested to Buy Any Domain ? << Click Here >> for more details...
what is phase to phase fault? what is line to line fault?
- 6 Answers
- 31107 Views
- I also Faced
- E-Mail Answers
Answer Posted / dharmesh ramani
Phase to Phase fault.
when you have 3 ph supply, at that time if any one phase came in contact with another phase without any Ground Contac and draw effectively high current and trip the circuit. that is called Phase to Phase fault. in this condition your connected load may be affected or damage due to failure of 2 phases.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is A check, B check, C Check & D check for a diesel Generat
Explain the working of variable frequency transformer?
Instrument connected to a single phase supply
What is the formula to calculate the rating of a three phase miniature circuit breaker
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
Define noise?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?
Can we use shunt trip coil instead of trip coil with protection relay for protection?
What Is HO factor in power selection
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
Is there chopping current in resistive circuit
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
block diagram of 2 ups system connected in hot stand by mode?
how to calculate the torque of a motor?
