Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sowbarniga soundararajan
DC motors are work on the principle of electro magnetic interaction.
Whenever the current carrying conductor placed in magnetic field, Due to the interaction of field flux and conductor flux the force will be active on the conductor and tend to move the conductor either in upward or downward direction according to current direction.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
which type of zones used for boiler? & why ?
Calibration procedure for Electro magnetic Flow meter
What is intrinsically safe system?
Why even multiple power supplu r used in instrumentation system?
what would be the minimum flow rate that we can measure on rotameter..?
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
what are the steps I have to deal with?
What is stripper & spilitter ? Diffrence in this.?
How to work temperature gauge?
how to relay switch sense the fault?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
