Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.v.chandramouli
pounds per Square Inch gauge
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Sir , i have completed my M.Sc In Instrumentation and presently working in Maintenance department 3 yrs Exp , is there is any possible for work in offshore ..
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
What is profibus?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Identification of control valve parts.
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
what are the different types of Protocols? & their applications.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
What is the procedure of calibration of Load cell?
