width rangs in NH,SH in one-way lane &two-way lane why we
are provid caber is there any reson for that
- 1 Answers
- 2511 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish thakur
NH-one way lane=7m to 8m.
NH=two way lane 15m to18m.
same for SH
camber to beused as flow the water from road embackment.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
How to find permissible diagonal tensile stress in reinforced brick work
what are the values of compressieve strenght?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
What is a kip?
what is idealized curve for concrere and steel
Why do you want to work here
why development length = 50D . why not 100D
what is concrete canvas?
Exterior Joints,define
What is the use of offset command?
what is the meaning of degreasing of the euipment or line.
SAND AND STONE AGGREGATES WASTAGE PERCENTAGE IN CONCRETING WORK?
Where is the worlds longest elevator and how long is it?
