Interested to Buy Any Domain ? << Click Here >> for more details...
What is main purpose of chock coil and starter in florescent tube ?
- 1 Answers
- 2064 Views
- I also Faced
- E-Mail Answers
Answer Posted / mksaini509
Chock coil for limiting current while starter for providing high voltage spike at starting
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Do inductive loads have distorted current waveforms ?
If a high resistance fault occurs,then what are the changes will happen in the system?
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
how to design the heater in temperature control unit to heat 50KL of water?
how to build a network which step down 415v to 1v rms
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
How is the percentage impedence of a transformer fixed at design stage???
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
what is a bus post insulator? explain its application in a substation.
how we sesign the transformer give some specifion regarding design of transformers
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How to calculate the heat load for a electrical room
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
what is current check gurd relay?
