Interested to Buy Any Domain ? << Click Here >> for more details...
What is OLTC AND RTCC and it's function?
- 2 Answers
- 5600 Views
- Sterling Wilson, I also Faced
- E-Mail Answers
Answer Posted / prakash
1.OLTC stands for On Load or Off load tap changer. It is generally used in power jobs.In case
of Off load tap changer we must have shut down the transformer to change the tap
position but in case of On load tap changer we does not need to shut down the
transformer we change the tap position in running status of a transformer .
2.In case of on load tap changer a resistance is used to hold the current when we change
the tap position in running status of transformer for a short duration of time when tap is
change from one position to another if we not use the resistance the current is flow
back & coil is burnt.
RTCC stands for Remote tap changer controller .It consists of various switch i.e voltage up & down button ,tap changer button etc . It is connected to the transformer via OLTC and generally kept inside the substation for controlling the transformer and also all the important alarms are fit in it .so, we carefully look after the transformer by the help of it at a distance from the transformer
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why to keep capacitor bank off while generator running.
Can the output voltage of a rectifier be greater than the input AC voltage without the use of any voltage multiplier in the circuit??please provide the explanation too..
how many Classification of fire extinguisher
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
how we can calculate the efficiency of a diesel generator ?
why we use condenser in the thermal power plant, althrough the same vapour will be again heated
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
what is RFID? thire application;
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
