Is there any decided or standard frequency to check the
meager testing of transformer, DG set, LT Panel in the
industries in a year.
I means how many times we should be check the same.
- 2 Answers
- 3670 Views
- I also Faced
- E-Mail Answers
Answer Posted / nagesh.patwari
Yes as per NBC It's in summer and twice in a year.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What information we need to prepare relay coordination chart
Please define ohm’s law for a.c (alternating current)?
what is W.T?specify the acceptable range?
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
what is mean by ideal infinite bus? why it is required to consider in fault short circuit calculations?
Why power factor should not be in leading (capacitive) mode of any load.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
what is the size of cable for 15kw motor and 85 meter cable length using with vfd
What Is HO factor in power selection
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
What are the basic components of the feedback control system?
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
