Interested to Buy Any Domain ? << Click Here >> for more details...
In LRS how much water PH value maintain for good operation
of motor?
- 3 Answers
- 18614 Views
- I also Faced
- E-Mail Answers
Answer Posted / jai kumar suman
It must be above 9
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Why reactors use before incoming of ac vvfd drive?
what kinds of Transformer oil grade is better for power transformer ?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
Difference between megger test equipment and contact resistance meter test instruments?
How can two 3 phase transformers of same KVA and Voltage be connected in parallel?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
what is two point starter?
What is the comparison of PILC and XLPE cable
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
rajha power sector details
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
for compensate 315mh inductance ,how many capaciance required?
help me with the question that might be ask on the interview for technical position
If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
