Answer Posted / prabakaran
Fire pump is used high rating pumps.its running sudden time at time elcp means automatically fall down because fire pipe connection is their in entire building so complesery connect any electrical distortion.so automatic ELCB tripped
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can anybody tell me that for p.f. Improvment we use capacitor banks but how to decide its capacitance. As we all know how to calculate kvar but what abt capacitance value
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
WHAT IS DIFFERENCE BETWEEN CAPACITOR AND CAPACITANCE?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
why we use 630mm single core cable for transformer secondary side and why two neutral cable
Readings of ER300P Trivector meter
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
ho can we calculate the conductor insulation value according to their ratings like voltage,current etc.how insulation value related with voltage,current and power of amachine
Define pole pitch?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
Give some differences between open loop and closed loop?
How can I model an open-delta ground transformer for a network supplied by 4 unit GTG and power transformer in ETAP?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??