Explain the working principle of servomotor
- 20 Answers
- 50073 Views
- ABB, Bhel, FANUC, GE, Jindal Steel and Power, L&T, SIA, Steelco Gujarat Ltd, I also Faced
- E-Mail Answers
Answer Posted / vishal kumar
Servo motor works on the principle of Electromagnetic Induction.
There are 3 pins or terminal are present.
1. Supply voltage
2. ground
3. Error signal
It is a close loop mechanism.
It always compares the error signal and the reference signal .
And the shaft will rotate only when the voltage is applied to it and it gets stop after removal of supply voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
can anybody sent me power grid questions. what subject should i prefer for preparation?
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
how to calculate the distance relay faulty zone?pls explain?
Why delta star trformers are used for lighting loads?
What are the differences between single phase and three phase?
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
what is saturation kit?which use above 15 kw motors panel side.
why in an industry; machine having rated 200 h.p stopped after power factor is maintained above 0.97 lag by control panel in view-of energy saving
Hoe do calculate the Cable size for Amps rating ?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
what is the physical connection of a analog i/p to a analog i/p module (ab plc)and through a analog o/p module(ab plc) to a analog o/p . and how all the process control by scada
