Interested to Buy Any Domain ? << Click Here >> for more details...
how can we detect that which is receiving side and which is
sendind end of a trnasmmison line by just seiing it?i.e its
which end is coming from genertaing and distribution side?
- 5 Answers
- 6851 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhishek dwivedi
I Just try to give the answer, if we want to see where the power transmitted it means from generation end to distribution end, then it can be check thru waves of stand water pond where there is no wave but if high transmission line route distributed from its top side then there will be waves in water, witch can mean of power flow.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the Transformer Impedence?How can calculate?
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
what is arc flash and what are the hazards involved
why high speed tripping relay is used in protection circuit why not normal relay
why we use four type of phase angle difference between pimary & secondry winding of a transformer & where we use them?
Draw a block diagramof Three UPS systems connected in Parallel mode?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
explain transformer ct connection?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
why it is not advisable to run low rating (19KVA) DG sets in parallel for long durations even though they are provided with droop ckts (QDC)
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
Why derivative controller is not used in control systems?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
