Interested to Buy Any Domain ? << Click Here >> for more details...
What can cause bulk solids to stop flowing from a bin?
- 1 Answers
- 6032 Views
- I also Faced
- E-Mail Answers
Answer Posted / ishan
Causes of such problems can fall into one of two categories: Material strength or Bin Geometry. In some cases, the combination of gravitational and frictional forces at some point in the container causes the solids to arch or bridge. So nearly all large bins contain an "arch-breaker" ( an upward pointing shallow metal cone set near the bottom) and can be stopped also because of rat flow (or) erratic material flow.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain what is the method involved in analyzing powders for composition?
What are some common problems associated with dilute phase pneumatic conveying?
What is maximum recommended velocity for steam in a plant pipe network?
What are the uses of quicklime?
Define viscosity?
hai please please if any one have useful test related and interview based question plz send me at saify_0@hotmail.com i will be thankfull
Should slurry pipes be sloped during horizontal runs?
How does hollow shaft impeller works? Does it based on principle of pitot tube?
What particle sizes are electrostatic precipitators used to remove?
Why in a continuous plant for a Hot standby screw pump system the interlock for auto starting of the other pump ( when the running pump stopped suddenly) is given with header pressure only? why not with flow rate or current of the pump?
How much maximum power can be generated by 320v, 10kg-cm synchronous motor if shaft is rotated mechanically at 50 to 60 rpm?
white rust formation over zinc plated and yellow passivated fasteners during CED painting. WHY?
how can I find out a sulfuric acid recovery plant disigner?
What are the specialized crushing methods?
Where the Induced draft, forced draft & balanced draft furnace are to be used? Selection of furnaces are based on which criteria?
