Why we transmit the power at the voltage in the multiple of
11 or 1.1 like 11kv, 22kv, 66kv, 132kv...... some one told
me that it is due to fomr factor 1.1 of sine wave. its fine
but while transforming we can choose any voltage, so why
only multiple of 1.1 there also.......? plz tell me.
Answer Posted / raghunath
Due to the losses. Some power is loses due to the conductor resistance while transferring 11kV at one end we may get less than that cause of that we send 11kV to get 10 kV (nearly).
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
What is the function of probe in cro?
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
how to calculate IR value of 33KV cable ??
Why do we require transformer with less specific weight if supply frequency is increased?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
boiler is running in rankine cycle and deisel generator is....?
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
What is online and offline ups? how does it works?
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
How two nos. 130 kw D.C motor get synchronise using D.C drive.
surge tank, hrc fuse, earthing transformer, firm power objective type
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
how to identify vector group of three phase transformer by voltage method?
Pls explan the OLR setting in VCB at HT yard