Answer Posted / essam s. salib
Uo in under ground cables is the voltage between any phase and the sheath surrounding the cable, while Uo in OH lines is the voltage between any phase and the ground through the line stray capacitance.
U is the voltage difference between any two phases either cables or OH lines.
Um is the maximum operating line voltage between phases
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
is it value of power factor is more than unit. whats effects in the source supply
what is the purpose of silicon dropper used in battery charger?
What is the armature mmf in a D.C machine?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
when we have to purchase the transformer by own i.e how much load will preferred HT connection?
Define conversion efficiency of a power amplifier.
Why two phase welding machine is used instead of three phase welding machine.
what will be the maximum winding temperature of 6.6kv HT motor 450kw, Full load current 49A. 50Hz Frequency.
volts=230 c=10mf a=??
when ID fan will immediately stop through VFD what exactly cause and problem the ID fan
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
what is a bus post insulator? explain its application in a substation.
If short circuit ratio is high is it bad or good for a machine then tell the reason...
WE ARE PLACE A NEW 75 KW MOTOR FOR JPF.IT IS CONNECTED IN M.C.C. WHEN WE ARE STARTING M.C.C.INCOMER IS TRIPPED.THEN WE ARE CONNECTED IN P.C.C WITH A MM30 RELAY PROTECTION THEN WE ARE STARTED MOTOR WILL RUN SMOOTHLY.
how to calculte capacitor range for single phase induction motors??pls tel