I have two AC generators, the first rated 2680KVA for
380V/4345A/pf:0.7 and the second rated 3461KVA for
5500V/363A/pf:0.8. I want to parallel the two generator to
a bus. The second generator passes through a transformer to
down the voltage to 380V and a part of its power goes to
another bus so that it's only a part of the total power of
the second generator taht goes to the considered bus. I
have two Basler DECS100 AVR regulator. How can I make the
synchronization ? What others equipments must have ?
- 1 Answers
- 2042 Views
- CST, I also Faced
- E-Mail Answers
Answer Posted / naseeb jangra
Before doing the parallel Supply both of DG You must Know that:-
Voltage is same
P.F is Same
Frequancy is also same.
This should be done manually or by synchronize the Supply with plc.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the difference between torque induced and torque load?compare them with respect to dc motor?
List examples of current sources?
how to calculate vfd o/p voltage by frequency
what is the difference between circular wdg & ractangular wdg?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
I need HT sphere gap calibration table. Can any body help me.
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
what is droop control?
how generator load test is conducted?what are the steps?
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
What happen in ups if phase reverse?
what is meant by IGBT how they differ from tyristor ?
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
What is center gravity load in substation?
